Rubber-To-Metal
Bonding
Quality Custom Rubber
Molding Services
Since 1976.
ISO 9001:2008
Rubber-To-Metal Bonding.
The process used to bond rubber to metal depends upon the application, specifically the use of the finished product. Rubber-to-metal bonding is an ideal process for bonding metal and plastic parts including: gears, shafts and rollers in a wide array of sizes and shapes. Additional uses for this process include rubber components bonded to steel, aluminum, brass and plastic.
Our knowledgeable technical staff can assist manufacturers with product development, design and select the right rubber-to-metal bonding agents for the performance requirements of the application. Our goal, with every project, is to produce uniform, high quality products as efficiently as possible. We develop customized rubber-to-metal bonded solutions to meet customer requirements.
ENCAPSULATED Spring
Rubber to metal compression molding.
CLICK HERE to view our photo gallery of parts produced by all three major rubber molding processes.
Contact a member of our technical staff at (330) 336-6777
or CLICK HERE to send us a drawing.
AMERICAN MADE PRODUCTS FROM AN AMERICAN OWNED COMPANY.
Our technical staff is available to answer any questions call (330) 336-6777, fill in the form below or CLICK HERE to send us a drawing.
Large Press Capability
We can support your largest part requirements with the ability to run 42” x 42” and 48” x 56” molds on our transfer molding and compression molding equipment.
Large Shot Capability
Rubber Injection Molding 10lb – 15lb – 20lb shot size
- Qualiform Rubber Molding, Inc.
- |
- 689 Weber Drive
- |
- Wadsworth, Ohio 44281
- |
- P: (330) 336-6777
- |
- F: (330) 336-3668