Nitrile Molding
Quality Custom Rubber
Molding Services
Since 1976.
ISO 9001:2008
Nitrile Molding.
Chemical Designation: Butadiene Acrylonitrile (NBR)
We recommend nitrile rubber molding when oil resistance is required. It is resistant to mineral, vegetable and petroleum oils, solvents and hydraulic fluid. It is able to resist heat and exhibits good resilience and abrasion resistance, as well as low permanent set. Nitrile is a resilient and stretchable polymer/ elastomers.
Do not use Nitrile for applications where oil resistance is not a major concern because of its cost. It demonstrates a poor resistance to acetone, ketones, hydrocarbons and the ozone.
Qualiform Custom Rubber Molding creates quality custom rubber compression molding, custom transfer molding, custom rubber injection molding and rubber-to-metal bonding with the highest standards in customer service.
Common Tags: Nitrile rubber molding, compression molding, transfer molding, injection molding, rubber to metal bonding, rubber parts manufacturer, rubber products manufacturer, compression molded, transfer molded, injection molded.
CLICK HERE to view our photo gallery of parts produced by all three major rubber molding processes.
Contact a member of our technical staff at (330) 336-6777
or CLICK HERE to send us a drawing.
AMERICAN MADE PRODUCTS FROM AN AMERICAN OWNED COMPANY.
Our technical staff is available to answer any questions call (330) 336-6777, fill in the form below or CLICK HERE to send us a drawing.
Large Press Capability
We can support your largest part requirements with the ability to run 42” x 42” and 48” x 56” molds on our transfer molding and compression molding equipment.
Large Shot Capability
Rubber Injection Molding 10lb – 15lb – 20lb shot size
- Qualiform Rubber Molding, Inc.
- |
- 689 Weber Drive
- |
- Wadsworth, Ohio 44281
- |
- P: (330) 336-6777
- |
- F: (330) 336-3668
